[ATTACH] [ATTACH]
three layers of glass over the marine grade plywood and three layers of gelcoat over the glass
these are todays pictures
i bought my Hydrodyne in 2016 and it turned out to be a total rebuild from the transom up, new stringers, floor, upgraded the transom from a full...
ok ty all i am just in the process of putting the motor well back on the boat the boat then new carpeting or better then seating, gauges, wiring...
thank you for all the info the project is much more then i was expecting but has been fun, so when it is ready for the water i want it to hall...
thank you i am in Canada West Coast close to Oregon i am doing a total resort on the 18 foot Hydrodyne i have a new 3 inch transom, stringers,...
has anyone used a jackplate on a Hydrodyne around 1970 to 1974, I HAVE A SHORT SHAFT JOHNSON 115 HP but want to go bigger to a 200 to 300 hp but...
I also have an A0720515 plate that came off the starboard side inside the boat like you not sure what this number is and trying to register the...
ty very much for the reply
hello, I am slowly rebuilding my 18 foot hydrodyne, have had the transom replaced and added an inch to make it 3 inches thick, now I am replacing...
thank you very much for the help, want to do it right.
hello team, it has been a cold wet winter here in BC CANADA so my rebuild was on hold. I rebuilt my 115 Johnson while the boat work stopped, now...
ty I can not find any hull numbers so is there anything i need to do to be able to register the boat I live in Canada
ty i did get down to the bulsa wood core and only about a foot of the core area at the transom was wet so i will replace that area
today i worked a little more on the Dyne, the transom almost clean of all wood as well as a section of the bulsa wood floor core. to make things...
i have been looking for the HID for my Hydrodyne and until now there was no numbers to be found. I have been working on replacing the floor,...
thank you i will look deeper
these are the current pcitures of the restoration, the hull and cap all one piece is this an after thought
being new this year to the Hydrodyne world i bought a project boat, the floor is almost out, just started on the transom fully rotted out due to...
Separate names with a comma.