Great job! Eric
Never drill holes in the deck of a Dyne or yours will end up a project like mine
Sorry it's been so long. Chad- It was not easy... It took a lot of care to get all the wood out from the bow, even more work to make the pieces...
Thank you JIm:) Eric
Between divorce, moving, sitting in storage, and working on her, 5 years lol
[ATTACH]
[ATTACH] It's finished
Thank you Jim! You were correct on the carb issue I was having. Sorry it's been so long. I have been enjoying it after getting it all cleaned out...
My transom was solid as a rock but i guess it is possible for it to wick into it. I guess i was just lucky. there was only resin between the...
Hi guys, just wanted to let all know I finally got her running. made it to the sand bar today! Also went for a cruise around Johnsons island and...
I have a 1960s 1600 also and it has a 40HP Johnson with a 15 inch transom and it is a little bit rough in small chop at high speeds. It also is a...
I gave up on this carb thing and finally took it to the johnson dealer to have it repaired. Got it back yesterday and went for a ride, guess what!...
I would like to have a new set. I only have one and the H looks like h.
Where did you find your front rub rail?
Yes, the season is ending way to fast for me. It is starting to get cold here in Ohio. But I am determined to keep going strong till the end of...
Ok I did it again, took the entire carb apart for the third time and I hope I got it all this time. I can start it but it will not idle. Fuel is...
The idle transfer circuit is clear i hosed the hole thing in carb clean and then blew it all out with my air compressor. I could see plenty of...
I went through the carb again and now i can get it to idle and throttle up but i have no high RPM under a load. It sounds like it is really...
Separate names with a comma.