1987 Hydrodyne 17.6XB Purchased last July from Boulder Marine in Longmont CO. The boat was used as a ski school boat up until early 2000 and then stored indoors for the next 10+ years at their shop. Hull and transom are rock solid, no cracks. All trim pieces have been cleaned and teak oil applied. I removed all decals, trim, interior, fuel and oil tank. I had the sidewalls and the bench seat reupholstered at Timberline Auto Trim in Colorado Springs at a cost of $900. The trailer is ugly and needs some paint but is solid with new tires this spring. I pulled the boat 150 miles with no issues. Glass windshield is like new. This is a solid boat, not structural issues just a couple gouges in the gel coat that I repaired with marine tex and then covered with some gel coat repair. I'm in school until 15 May and I may drive back to Wisconsin to pick up my other rig . If I drive (vs. have my dad bring the other boat out here), I would be willing to tow this hull back with me. I'll include the Johnson Controls (big red plug) and hydraulic steering if interested. Additional pictures on ebay: http://www.ebay.com/itm/171770238907?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 BOAT IS LOCATED IN COLORADO SPRINGS COLORADO